>
> I manage a list using listproc. 7.0. I've been trying to send commands
> via email to the listproc to change various configurations of the list.
>
> I keep getting error messages back because I have not properly typed in
> the commands in the correct sequence.
>
> If someone out there is familiar with using listproc 7.0 please write an
> example of how I would change the list so that one of its configurations
> reads REPLY-TO-LIST rather than REPLY-TO-SENDER.
>
> Thanxs.
>
> Aaron Goldsmith
> SYSOP
> List: UAHCAMPUS (nysernet)
>
This is not a support list for 7.0; you need to contact CREN (If you
have 7.0 you surely have CREN's email address).
At any rate, the syntax is:
conf list password reply-to-list
Tasos
References:
|
|
