Someone know if DrawBrigde is able to filter IP packets for one IP
address rather than the while subnet? I'm looking for a product that is
able to pick up a packet if it matches the IP of a single host and router
it to another ethernet network.
Network A | Network B | Network C
| |
| |
.-----------. .----------------.
| IP filter | ---------> | Firewall/Proxy |
`-----------' `----------------'
eth0 | eth1 eth0= | eth1 = 192.168.100.200
Network = | 192.168.1.1 |
192.168.1.0 | |
The IP filter shouldn't have to have any IP addresses, if it sees a packet
that is addressed to the firewalls eth interface 0 (192.168.1.1) that is
running on 192.168.1.0 network (IP filters eth0) it copies the packet to
the eth1 interface and vise versa. Uses an access-list. Does such a
product exist? Is it possible by the way?
best regards, Gunni
=========================================================================
Gunnar Ingvi Þórisson E-Mail address: gunni @
if .
is
=========================================================================
Follow-Ups:
|
|
