Excuse me..The documentation led me to believe that you could use
newconfig to modify select parameters of a configuration. I must have
been reading too fast.
Doug Birdzell, Programmer
Husky Labs
3618 Falls Road, #300
Baltimore, MD 21211
(410)-889-3409 voice
(410)-889-8489 fax
On Fri, 19 May 1995, Dave Wolfe wrote:
> [ Doug Birdzell writes: ]
> >
> > Try this
> >
> > newconfig <yourlistname> <yourlistpasswd>
> > restrict_post <listname>
> > end
>
> No, don't. As written above:
>
> >>>> newconfig xxxxxx xxxxxxxxxxxxxxxxxx
> The new config file for xxxxxx was NOT accepted because:
> unknown key |restrict_post xxxxxx| in file xxxxxx.new.config at line 1
>
> If I put an '=' after 'restrict_post' it "works" in that it replaces the
> entire config file with that one line.
>
> --
> Dave Wolfe *Not a spokesman for Motorola* (512) 891-3246
> Motorola MMTG 6501 Wm. Cannon Dr. W. OE112 Austin TX 78735-8598
>
References:
|
|
