The answer is still no if you are talking about debugging majordomo. IF
you just want to enable debugging on a single list, you can do that via
the newconfig/writeconfig commands. Realize however, that in debug mode
messages never actually get sent through the list.
Dan Liston
Victor wrote:
>
> Can you do it by sending a new config file?
>
> On Tue, 26 Jun 2001 20:35:01 -0500, you wrote:
>
> >I saw this message asked before (probably you), but did not know the
> >answer. I will take a stab at this since nobody else has spoken up,
> >and say "no". Of course, you could dig into the majordomo.pl or even
> >the resend script to find out for sure.
> >
> >Dan Liston
> >
> >John Poltorak wrote:
> >>
> >> Is there any way to switch on debug mode via a cmd line parameter or
> >> environment variable?
References:
|
|
