Charlie,
Look for this entry in you listname.config. and fill in the appropriate
names...
# reply_to [word] () <resend,digest>
# Put a reply-to header with value <value> into the outgoing
# message. If the token $SENDER is used, then the address of the
# sender is used as the value of the reply-to header. This is the
# value of the reply-to header for digest lists.
reply_to = yourlistname@your.address
All relpies get the list 'pasted' in the reply, instead of anything
else.
Be warned, this causes a lot of communication on an active list. Plus
some people who aren't paying attention sometimes post to the whole
group and say things that are best kept private. :-) I have a few
lists that utilize this and it was a learning curve for most users.
--Casey Hatch
President: Z-Olite Inc.
phone: 435.563.1460
web: www.z-oliteinc.com
On Mon, Oct 27, 2003 at 09:23:37AM -0700, Charlie Smith wrote:
> How to make it so that internet users can't see all the lists that majordomo is serving?
> I've noticed that when you reply to some lists, the name of the list comes up by default. On other replies the name of the individual that posted to the list. I'd like to default to the list name. So, when you press reply in your email client, the name of the list comes up in the To: box instead of the user that posted the message you want to reply to.
>
>
>
> ------------------------------------------------------------------------------
> This message may contain confidential information, and is intended only for the use of the individual(s) to whom it is addressed.
>
>
> ==============================================================================
>
>
>
>
> ------------------------------------------------------------------------------
> This message may contain confidential information, and is intended only for the use of the individual(s) to whom it is addressed.
>
>
> ==============================================================================
>
--
References:
|
|
